^IDObject Delete
^ID configures object Delete. It applies to the printer session and subsequent formats and changes job or printer-session state used while processing labels.
These are code examples only. This printer or session command does not produce a standalone label image.
dLocation of stored object
Sets location of stored object. It can be omitted when the documented default is suitable.
- Default
R:- Required
- No
R:d variations
Compare values side by side; other parameters remain at representative defaults.
d = R:
Uses R: for location of stored object while the other command values stay at representative defaults.
^IDR::OBJECT.GRF
d = E:
Uses E: for location of stored object while the other command values stay at representative defaults.
^IDE::OBJECT.GRF
oObject name
Sets object name. It can be omitted when the documented default is suitable.
- Default
if a name is not specified, UNKNOWN is used- Required
- No
OBJECT18o variations
Compare values side by side; other parameters remain at representative defaults.
o = OBJECT
Uses OBJECT for object name while the other command values stay at representative defaults.
^IDR::OBJECT.GRF
o = 1
Uses 1 for object name while the other command values stay at representative defaults.
^IDR::1.GRF
xExtension
Sets extension. It can be omitted when the documented default is suitable.
- Required
- No
GRFx variations
Compare values side by side; other parameters remain at representative defaults.
x = GRF
Uses GRF for extension while the other command values stay at representative defaults.
^IDR::OBJECT.GRF
x = GRF2
Uses GRF2 for extension while the other command values stay at representative defaults.
^IDR::OBJECT.GRF2
Primary source
Official Zebra reference
Use the manufacturer reference for printer- and firmware-specific behavior beyond ZPLr’s pinned rendering profile.