Skip to command documentation
Device onlyprinterdevicesession scope
^JZ

Reprint After Error

^JZ configures reprint After Error. It applies to the printer session and subsequent formats and controls printer hardware or connectivity rather than label pixels.

ZPLr compatibility note

  • Recognized by the renderer but has no label-raster effect.

These are code examples only. This printer or session command does not produce a standalone label image.

Syntax
^JZa
a

Reprint after error

Sets reprint after error. It can be omitted when the documented default is suitable.

Required
No
Documented valuesYN

a variations

Compare values side by side; other parameters remain at representative defaults.

Side-by-side comparison2 variations

a = N

Uses N for reprint after error while the other command values stay at representative defaults.

Edit in editor
ZPLcaret-jz-a-1.zpl
^JZN

a = Y

Uses Y for reprint after error while the other command values stay at representative defaults.

Edit in editor
ZPLcaret-jz-a-2.zpl
^JZY

Primary source

Official Zebra reference

Use the manufacturer reference for printer- and firmware-specific behavior beyond ZPLr’s pinned rendering profile.

Open Zebra documentation