^MFMedia Feed
^MF configures media Feed. It applies to the printer session and subsequent formats and controls printer hardware or connectivity rather than label pixels.
ZPLr compatibility note
- Recognized by the renderer but has no label-raster effect.
These are code examples only. This printer or session command does not produce a standalone label image.
pFeed action at power-up
Sets feed action at power-up. It can be omitted when the documented default is suitable.
- Default
C- Required
- No
CFLNSp variations
Compare values side by side; other parameters remain at representative defaults.
p = F
Uses F for feed action at power-up while the other command values stay at representative defaults.
^MFF,C
p = C
Uses C for feed action at power-up while the other command values stay at representative defaults.
^MFC,C
p = S
Uses S for feed action at power-up while the other command values stay at representative defaults.
^MFS,C
hFeed action after closing printhead
Sets feed action after closing printhead. It can be omitted when the documented default is suitable.
- Default
C- Required
- No
CFLNSh variations
Compare values side by side; other parameters remain at representative defaults.
h = F
Uses F for feed action after closing printhead while the other command values stay at representative defaults.
^MFC,F
h = C
Uses C for feed action after closing printhead while the other command values stay at representative defaults.
^MFC,C
h = S
Uses S for feed action after closing printhead while the other command values stay at representative defaults.
^MFC,S
Primary source
Official Zebra reference
Use the manufacturer reference for printer- and firmware-specific behavior beyond ZPLr’s pinned rendering profile.