Skip to command documentation
Device onlynetworkdevicesession scope
^NW

Set Web Authentication Timeout Value

^NW configures set Web Authentication Timeout Value. It applies to the printer session and subsequent formats and controls printer hardware or connectivity rather than label pixels.

ZPLr compatibility note

  • Recognized by the renderer but has no label-raster effect.

These are code examples only. This printer or session command does not produce a standalone label image.

Syntax
^NWa
a

Timeout value

Sets timeout value. It can be omitted when the documented default is suitable.

Default
5
Range
0–255
Required
No
Documented values50

a variations

Compare values side by side; other parameters remain at representative defaults.

Side-by-side comparison2 variations

a = 5

Uses 5 for timeout value while the other command values stay at representative defaults.

Edit in editor
ZPLcaret-nw-a-1.zpl
^NW5

a = 0

Uses 0 for timeout value while the other command values stay at representative defaults.

Edit in editor
ZPLcaret-nw-a-2.zpl
^NW0

Primary source

Official Zebra reference

Use the manufacturer reference for printer- and firmware-specific behavior beyond ZPLr’s pinned rendering profile.

Open Zebra documentation