Skip to command documentation
Device onlyprinterdevicesession scope
^PF

Slew Given Number of Dot Rows

^PF configures slew Given Number of Dot Rows. It applies to the printer session and subsequent formats and controls printer hardware or connectivity rather than label pixels.

ZPLr compatibility note

  • Recognized by the renderer but has no label-raster effect.

These are code examples only. This printer or session command does not produce a standalone label image.

Syntax
^PF#
#

Number of dots rows to slew

Sets number of dots rows to slew. It can be omitted when the documented default is suitable.

Default
a value must be entered or the command is ignored
Range
0–32000
Required
No
Documented values032000

# variations

Compare values side by side; other parameters remain at representative defaults.

Side-by-side comparison2 variations

# = 0

Uses 0 for number of dots rows to slew while the other command values stay at representative defaults.

Edit in editor
ZPLcaret-pf-value-1.zpl
^PF0

# = 32000

Uses 32000 for number of dots rows to slew while the other command values stay at representative defaults.

Edit in editor
ZPLcaret-pf-value-2.zpl
^PF32000

Primary source

Official Zebra reference

Use the manufacturer reference for printer- and firmware-specific behavior beyond ZPLr’s pinned rendering profile.

Open Zebra documentation