Skip to command documentation
Device onlyprinterdevicesession scope
~JF

Set Battery Condition

~JF configures set Battery Condition. It applies to the printer session and subsequent formats and controls printer hardware or connectivity rather than label pixels.

ZPLr compatibility note

  • Recognized by the renderer but has no label-raster effect.

These are code examples only. This printer or session command does not produce a standalone label image.

Syntax
~JFp
p

Pause on low voltage

Sets pause on low voltage. It can be omitted when the documented default is suitable.

Default
Y
Required
No
Documented valuesYN

p variations

Compare values side by side; other parameters remain at representative defaults.

Side-by-side comparison2 variations

p = Y

Uses Y for pause on low voltage while the other command values stay at representative defaults.

Edit in editor
ZPLtilde-jf-p-1.zpl
~JFY

p = N

Uses N for pause on low voltage while the other command values stay at representative defaults.

Edit in editor
ZPLtilde-jf-p-2.zpl
~JFN

Primary source

Official Zebra reference

Use the manufacturer reference for printer- and firmware-specific behavior beyond ZPLr’s pinned rendering profile.

Open Zebra documentation