~PMDecommissioning Mode
~PM configures decommissioning Mode. It applies to the printer session and subsequent formats and controls printer hardware or connectivity rather than label pixels.
ZPLr compatibility note
- Recognized by the renderer but has no label-raster effect.
These are code examples only. This printer or session command does not produce a standalone label image.
aPrinter’s serial number
Sets printer’s serial number. It must be supplied.
- Required
- Yes
0a variations
Compare values side by side; other parameters remain at representative defaults.
a = 0
Uses 0 for printer’s serial number while the other command values stay at representative defaults.
~PM0,0
a = 1
Uses 1 for printer’s serial number while the other command values stay at representative defaults.
~PM1,0
bNumber of times for the flash wipe-out to occur
Sets number of times for the flash wipe-out to occur. It can be omitted when the documented default is suitable.
- Required
- No
0b variations
Compare values side by side; other parameters remain at representative defaults.
b = 0
Uses 0 for number of times for the flash wipe-out to occur while the other command values stay at representative defaults.
~PM0,0
b = 1
Uses 1 for number of times for the flash wipe-out to occur while the other command values stay at representative defaults.
~PM0,1
Primary source
Official Zebra reference
Use the manufacturer reference for printer- and firmware-specific behavior beyond ZPLr’s pinned rendering profile.