Skip to command documentation
Device onlyprinterdevicesession scope
~RO

Reset Advanced Counters

~RO configures reset Advanced Counters. It applies to the printer session and subsequent formats and controls printer hardware or connectivity rather than label pixels.

ZPLr compatibility note

  • Recognized by the renderer but has no label-raster effect.

These are code examples only. This printer or session command does not produce a standalone label image.

Syntax
~ROc
c

Counter number

Sets counter number. It can be omitted when the documented default is suitable.

Default
a value must be specified or the command is ignored
Required
No
Documented values1234CR

c variations

Compare values side by side; other parameters remain at representative defaults.

Side-by-side comparison3 variations

c = 1

Uses 1 for counter number while the other command values stay at representative defaults.

Edit in editor
ZPLtilde-ro-c-1.zpl
~RO1

c = 2

Uses 2 for counter number while the other command values stay at representative defaults.

Edit in editor
ZPLtilde-ro-c-2.zpl
~RO2

c = R

Uses R for counter number while the other command values stay at representative defaults.

Edit in editor
ZPLtilde-ro-c-3.zpl
~ROR

Primary source

Official Zebra reference

Use the manufacturer reference for printer- and firmware-specific behavior beyond ZPLr’s pinned rendering profile.

Open Zebra documentation