Skip to command documentation
Device onlyprinterdevicesession scope
~TA

Tear-off Adjust Position

~TA configures tear-off Adjust Position. It applies to the printer session and subsequent formats and controls printer hardware or connectivity rather than label pixels.

ZPLr compatibility note

  • Recognized by the renderer but has no label-raster effect.

These are code examples only. This printer or session command does not produce a standalone label image.

Syntax
~TA###
###

Change in media rest position (3-digit value in dot rows must be used.)

Sets change in media rest position (3-digit value in dot rows must be used.). It can be omitted when the documented default is suitable.

Default
last permanent value saved
Range
-120–120
Required
No
Documented values0120

### variations

Compare values side by side; other parameters remain at representative defaults.

Side-by-side comparison2 variations

### = 0

Uses 0 for change in media rest position (3-digit value in dot rows must be used.) while the other command values stay at representative defaults.

Edit in editor
ZPLtilde-ta-value-1.zpl
~TA0

### = 120

Uses 120 for change in media rest position (3-digit value in dot rows must be used.) while the other command values stay at representative defaults.

Edit in editor
ZPLtilde-ta-value-2.zpl
~TA120

Primary source

Official Zebra reference

Use the manufacturer reference for printer- and firmware-specific behavior beyond ZPLr’s pinned rendering profile.

Open Zebra documentation