^NCSelect the Primary Network Device
^NC configures select the Primary Network Device. It applies to the printer session and subsequent formats and controls printer hardware or connectivity rather than label pixels.
ZPLr compatibility note
- Recognized by the renderer but has no label-raster effect.
These are code examples only. This printer or session command does not produce a standalone label image.
aPrimary network device
Sets primary network device. It can be omitted when the documented default is suitable.
- Default
1 must be an accepted value or it is ignored- Required
- No
12a variations
Compare values side by side; other parameters remain at representative defaults.
a = 1
Uses 1 for primary network device while the other command values stay at representative defaults.
^NC1
a = 2
Uses 2 for primary network device while the other command values stay at representative defaults.
^NC2
Primary source
Official Zebra reference
Use the manufacturer reference for printer- and firmware-specific behavior beyond ZPLr’s pinned rendering profile.