Skip to command documentation
Device onlynetworkdevicesession scope
~NC

Network Connect

~NC configures network Connect. It applies to the printer session and subsequent formats and controls printer hardware or connectivity rather than label pixels.

ZPLr compatibility note

  • Recognized by the renderer but has no label-raster effect.

These are code examples only. This printer or session command does not produce a standalone label image.

Syntax
~NC###
###

Network ID number assigned (must be a three-digit entry)

Sets network ID number assigned (must be a three-digit entry). It can be omitted when the documented default is suitable.

Default
000 (none)
Range
1–999
Required
No
Documented values000001999

### variations

Compare values side by side; other parameters remain at representative defaults.

Side-by-side comparison3 variations

### = 000

Uses 000 for network ID number assigned (must be a three-digit entry) while the other command values stay at representative defaults.

Edit in editor
ZPLtilde-nc-value-1.zpl
~NC000

### = 001

Uses 001 for network ID number assigned (must be a three-digit entry) while the other command values stay at representative defaults.

Edit in editor
ZPLtilde-nc-value-2.zpl
~NC001

### = 999

Uses 999 for network ID number assigned (must be a three-digit entry) while the other command values stay at representative defaults.

Edit in editor
ZPLtilde-nc-value-3.zpl
~NC999

Primary source

Official Zebra reference

Use the manufacturer reference for printer- and firmware-specific behavior beyond ZPLr’s pinned rendering profile.

Open Zebra documentation